|
|
This rugged, hand held, battery operated analyzer is very effective in diagnosing problems with solid state ignition modules, ignition generators, coils, shielded and unshielded ignition harnesses, ignition powered instruments, etc. |
The ACCUTEK III ® provides you with a full range of diagnostic features. Immediately identify defective components and quickly evaluate your entire ignition system - from start to finish. |
ACCUTEK III ® Ignition Analyzer Features: Easy to use Simple, step-by-step instruction manual and video Small, hand held design Battery operated (4 AA cells) Liquid crystal display for visual feedback Low battery indicator Rugged, high impact case |
Benefits: Extensive ignition module/ignition generator analysis Testing of coils, secondary leads, extensions, etc High voltage integrity testing (megger testing) Instrument and control panel testing |
Contact us at: |
Intelligent Ignition Analyzer The only equipment needed to fully diagnose shielded and unshielded ignition energy output, peak voltage and pulse duration. The ACCUTEK III® also acts like an ignition source, allowing full testing of shielded and unshielded ignition coils, secondary leads and extensions. |
Additional features of the ACCUTEK III® include high voltage (approx 200 to 900 volt) insulator integrity testing, missing pulse detection and CD powered instruments testing. |
INNOVATIVE TECHNICAL |
SOLUTIONS INC. |
Two unique features of the ACCUTEK III ® ignition analyzer are the missing pulse detector and the instrument test feature. The missing pulse detector allows the operator to connect the ACCUTEK III® analyzer to any individual primary lead or to the shutdown lead. The ACCUTEK III ® analyzer "learns" the engine firing pattern and alerts the user if the ignition system is not operating properly. This feature is very useful in determining if an intermittent misfire is caused by your ignition system or through other causes such as fuel or mechanical problems. The instrument test feature allows the operator to supply power to most capacitive discharge ignition powered instruments or devices. This allows the operator to power a panel and perform troubleshooting tests to the panel without starting the engine. The output voltage from the ACCUTEK III® is adjustable from approx. 100 to 350 VDC at a highly accurate, crystal controlled, 60 Hz. This highly stable 60 Hz output can also be used to verify tachometer accuracy. Shielded Ignition Coil Leads (click on image to enlarge) |
Contact us at: |
These accessories allow the operator to conveniently test the performance of shielded ignition coils for problems such as high voltage insulator breakdown, low secondary output, coil primary resistance, etc. *These trademarks are the registered trademarks for the respected companies |
24BP-ALT Used for testing Altronic®, 3 pin shielded coils |
24BP-FM Used for testing Fairbanks Morse/Holley® 2 pin shielded coils |
24T-ALT Inserted between primary lead and shielded or flange mounted 3 pin coils |
24BP-CAT Used for testing Caterpillar® EIS coils |
24BP-BS Used for testing Bosch®, 2 pin shielded coils |